Fujitsu SK-91460T-144PMC-GPIO User Manual page 36

2) If the programming software should generate a reset signal on RTS or DTR line, refer
to the following jumper list.
Jumper
JP20
(RTS-CTS)
JP89
(DTR/RTS)
JP16
(RST 0/4)
JP13
(DTR / DTRx)
JP38
(RST MCU)
3) The CPU Mode selection must be set to internal reset vector mode by setting DIP
switch S1 to (Off, Off, Off, Off) (only if DIP Switch mounted!)
4) Start the 'FME-FR Programmer' and connect the UART4 to your serial PC
communication port. A straight cable connection has to be used.
5) Choose the microcontroller device ("MB91F467T") as device type and browse to the
mhx-file you want to program to the embedded flash memory of the microcontroller.
Press the button "Automatic Mode" to start programming.
6) After that, immediately reset the microcontroller.
FMEMCU-UG-910074-11
SK-91460T-144PMC-GPIO User Guide
Chapter 6 Programming the internal Flash
Setting Description
Closed RTS and CTS of X2 are connected
Open RTS and CTS of X2 are not connected
1-2 DTR signal (Pin 6 of X2) is used as reset source
2-3 RTS signal (Pin 7 of X2) is used as reset source
Closed LIN-UART 4 (X2) connected to reset circuit
1-2 No negation for the DTR/RTS signal
2-3 DTR/RTS signal is negated
Closed External reset generation is active
Table 6-2: Jumper Settings for reset signal
- 36 - © Fujitsu Microelectronics Europe GmbH