Tables - Fujitsu SK-91460T-144PMC-GPIO User Manual

Mb91460 series

Table of Contents

SK-91460T-144PMC-GPIO User Guide

Chapter 8 Appendix

8.3 Tables

Table 1-1: Emulation System ................................................................................................. 8

Table 2-1: Jumper Settings .................................................................................................. 11

Table 3-1: MCU Operating Mode ......................................................................................... 14

Table 3-2: Power Switch ...................................................................................................... 15

Table 3-3: Power Supply Configuration................................................................................ 15

Table 3-4: Voltage Test Pins ................................................................................................ 16

Table 3-5: ADC Supply ........................................................................................................ 17

Table 3-6: UART 4 Settings ................................................................................................. 18

Table 3-7: UART 5 Settings ................................................................................................. 19

Table 3-8: UART 6 Settings ................................................................................................. 20

Table 3-9: UART 7 Settings ................................................................................................. 21

Table 3-10: CAN Settings .................................................................................................... 22

Table 3-11: Reset Connection.............................................................................................. 23

Table 3-12: User Push Buttons ............................................................................................ 24

Table 3-13: Potentiometer Settings ...................................................................................... 24

Table 4-1: UART Connector Signals .................................................................................... 26

Table 4-2: CAN Connector Signals ...................................................................................... 26

Table 4-3: User LEDs/LCD................................................................................................... 27

Table 4-4: In-circuit programming connector ........................................................................ 28

Table 6-1: Jumper Settings for Programming....................................................................... 35

Table 6-2: Jumper Settings for reset signal .......................................................................... 36

FMEMCU-UG-910074-11

- 42 -

Table of Contents