JVC MX-J300 Service Manual page 8

MX-J300
Removing the rear cover and the rear
panel (See Fig.13 to 16)
Prior to performing the following procedures, remove
the metal cover and the CD changer mechanism
assembly.
It is not necessary to remove the front panel
assembly.
1. Remove the two screws F and the rear cover on the
back of the body.
2. Remove the four screws G and the six screws H
attaching the main board and the heat sink to the
rear panel.
3. Remove the screw I attaching the rear panel to the
base chassis.
4. Release the lower two joints e and f on both sides of
the rear panel using a screwdriver and detach the
rear panel backwards.
1-8
F
Rear cover
G
(To Earth bracket)
H
G
Rear panel
Joint f
Rear panel
F
Fig.13
Rear panel
G
H
I
Fig.14
Joint e
Fig.15
Rear panel
Fig.16