Qos; Qos Settings; Figure 90: Add Or Modify A Static Route Entry - SMC Networks SMCWBR14S-N5 User Manual

Q S
O
Q S S
O ETTINGS

Figure 90: Add or Modify a Static Route Entry

Enter the following data:
2.
Destination IP Address - The Destination IP Address is the address
◆
of the network or host that you want to assign to a static route.
◆ Subnet Mask - The Subnet Mask determines which portion of an IP
Address is the network portion, and which portion is the host portion.
◆ Gateway - This is the IP Address of the gateway device that allows for
contact between the Router and the network or host.
Select Enabled or Disabled for this entry on the Status pull-down list.
3.
Click the Save button to make the entry take effect.
4.
Other configurations for the entries:
Click the Delete button to delete the entry.
Click the Enable All button to enable all the entries.
Click the Disable All button to disable all the entries.
Click the Delete All button to delete all the entries.
Click the Previous button to view the information in the previous screen.
Click the Next button to view the information in the next screen.
There are two submenus under the QoS menu, as shown in
any of them and you will be able to configure the corresponding function.
The detailed explanations for each submenu are provided below.
Select QoS->QoS Settings from the menu; you can configure the Egress
Bandwidth and Ingress Bandwidth in the next screen. The values you
configure should be less than 100000 Kbps. For optimal control of the
– 99 –
| Configuring the Router
C 4
HAPTER
Figure

QoS

91. Click