Table of Contents
Advertisement
34
en | Installing a Recessed Mount
6
Installing a Recessed Mount
6.1
Description
This chapter details how to recess mount the AutoDome Junior.
The AutoDome Junior is also suitable for surface
(Section 4 Installing a Surface Mount, page 21), wall
(Section 5 Installing a Wall Mount, page 27), and pipe mounting
(Section 7 Installing a Pipe Mount, page 43). For specific
directions on mounting the unit, see the manual that came with
your mount.
NOTICE!
The image sensors in modern cameras are highly sensitive and
require special care for proper performance and extended
lifetime. Follow the guidelines for optimum results with your
camera:
–
–
6.1.1
Additional Requirements
–
–
–
–
–
–
F.01U.172.910 | 4.0 | 2011.09
Do not expose to direct sunlight or bright spotlights in
operating and nonoperating conditions.
Avoid bright lights in the field of view of the camera. Bright
lights cause a "smearing" effect, which is visible as white
lines above and below the highlight. Prolonged exposure to
bright lights may cause bleaching of the sensor's color
filters. This will be visible as colored spots in the picture
and is irreversible.
Appropriate straight slot screwdrivers
No. 2 Phillips screwdriver
Appropriate tool for cutting a hole in drywall or ceiling tile
(if applicable)
4 in. x 4 in. junction box (optional)
T-10 Torx wrench
VJR-A3-SP, support kit for VJR-A3-IC mounting kit
Installation Manual
AutoDome Junior HD
Bosch Security Systems, Inc.
Advertisement
Table of Contents
