Turn On The Tv; Complete The Initial Setup; Set The Menu Language; Complete Auto Channel Search - GE HDTV Monitor User Manual

Hdtv monitor

Table of Contents

Tip

To access the setup menus manually, press

MENU and choose SETUP.

Chapter 1

Turn on the TV

Press TV on the remote, or press POWER on the TV's front panel.

Note: Pressing the TV button not only turns on the TV, but puts the remote

into TV mode. "TV mode" means that the buttons on the remote control

operate the TV's functions.

The menu system in your TV allows the TV's features to work properly. The first

time you turn on your TV, the setup screens appear. Complete the entire setup

sequence including Auto convergence to prevent the setup screen from appearing

the next time the set is turned on.

The first part of the setup allows you to select your preferred language for the

menu system.

If English is your preferred language, press OK. If you want to choose another

language, press the down arrow button until that language is highlighted, and

press OK.

The next screen asks you to make sure you've connected the TV to a cable,

satellite, or off-air signal. When you're sure that a signal is connected to your TV,

press OK on your remote to go to the Channel setup screen.

In the Channel setup screen, you can launch the Auto channel search by

pressing OK. The Auto channel search allows the TV to search for all channels

viewable through your antenna or cable TV system. This is sometimes called auto

programming. When the channel search is complete, press OK to access the List &

Labels screen.

Connections & Setup

Continues on next page...

Table of Contents