Tv + Dvd + Vcr - GE HDTV Monitor User Manual

TV + DVD + VCR

1. Connect your DVD Player to your TV.
A. Connect the audio (white and red) cables to the CMP1 L and R audio input jacks on the
back of the TV and to the audio output jacks on the DVD player.
B. Connect three video grade cables to the CMP1 Y PB PR input jacks on the back of the TV
and to the Y PB PR output jacks on the DVD player.
Notes:
If your DVD player does not have Y PB PR jacks, but does have an S-Video jack, connect the
player to the VID1 S-VIDEO jack on the TV using an S-Video cable.
If your DVD player does not have an S-Video jack, connect the player to the VID1 V (Video)
jack on the back of the TV using a video cable.
Important: If you use the VID1 S-VIDEO or V (Video) jack to connect your TV to the DVD
player, you must connect the audio cables to the VID1 L/MONO and R jacks on the TV.
2. Connect your VCR to your TV.
A. Connect a coaxial cable to the VCR's antenna output jack and to the ANTENNA/CABLE
input jack on the TV.
B. Connect the audio (white and red) cables to the VID2 L/MONO and R audio input jacks on
the back of the TV and to the audio output jacks on the VCR.
C. Connect the video cable to the VID2 V (Video) jack on the back of the TV and to the video
output jack on the VCR.
3. Make sure cable or antenna is connected to your VCR.
Connect the coaxial cable from your cable outlet or antenna to the antenna input jack on the
VCR.
Chapter 1
Connections & Setup
Go to page 14
11