Installation Instructions Preparing to Install the Refrigerator ....13 Reversing the Door Swing ..18–22 Water Line Installation ..14–18 Troubleshooting Tips .
Installation Instructions before it is used. Do not allow children to climb, stand or hang on the shelves in the refrigerator. They could damage the refrigerator and seriously injure themselves. Do not touch the cold surfaces in the freezer compartment when hands are damp or wet.
This provides the best performance and also prevents overloading house wiring circuits which could cause a fire hazard from overheated wires. Never unplug your refrigerator by pulling on the power cord. Always grip plug firmly and pull straight out from the outlet.
3 SECS IS COLDEST IS COLDEST Initially, set the refrigerator control at 5 and the freezer control at 5 and allow 12–24 hours for the temperature to stabilize. Several adjustments may be required. Adjust the controls one increment at a time, and allow 12 hours after each adjustment for the refrigerator to reach the temperature you have set.
24 hours for the temperature to stabilize to the preset recommended settings. The temperature controls can display both the SET temperature as well as the actual temperature in the refrigerator and freezer. The actual temperature may vary slightly from the SET temperature based on usage and operating environment.
Water Filter Cartridge The water filter cartridge is located inside the cartridge holder in the back upper right corner of the refrigerator compartment. NOTE: Some models ship with the filter bypass plug in place of the filter cartridge. The filter bypass plug needs to be removed before the filter cartridge is installed.
About the shelves and bins. Not all features are on all models. Rearranging the Shelves Shelves in the refrigerator and freezer compartments are adjustable. Refrigerator Compartment To remove: Tilt the shelf up at the front. Lift the shelf up at the back and bring the shelf out.
Adjustable Bins on the Door Finger hold Snugger Adjustable bins can easily be carried from refrigerator to work area. To remove: Lift the bin straight up, then pull out. To replace or relocate: Engage the bin in the molded supports of the door, and push in.
(on some models) The settings can be adjusted anywhere between cold When set at cold, the pan will stay at the normal refrigerator temperature. The coldest setting provides the coldest storage area. www.GEAppliances.com and coldest...
To Remove: These drawers can be removed easily by lifting up slightly while pulling the drawer past the stop location. About the automatic icemaker. A newly-installed refrigerator may take 12–24 hours to begin making ice. Automatic Icemaker Power Switch Icemaker The icemaker will produce seven or eight cubes (depending on model) per cycle—...
Do not wipe the refrigerator with a soiled dish cloth or wet towel. These may leave a residue that can erode the paint. Do not use scouring pads, powdered cleaners, bleach or cleaners containing bleach because these products can scratch and weaken the paint finish.
To remove the light shield, grasp the shield as shown. Squeeze the shield and rotate the shield toward the back of the refrigerator. The light shield will pop out. Freezer Compartment Light CAUTION: Unplug the refrigerator.
Warranty. WATER SUPPLY TO THE ICEMAKER (ON SOME MODELS) If the refrigerator has an icemaker, it will have to be connected to a cold water line. A GE water supply kit (containing tubing, shutoff valve, fittings and instructions) is available at extra cost from your dealer, by visiting our Website at www.GEAppliances.com (in...
To determine how much tubing you need: measure the distance from the water valve on the back of the refrigerator to the water supply pipe. Then add 8′ (2.4 m). Be sure there is sufficient extra tubing (about 8′ [2.4 m] coiled into 3 turns of about 10″...
(available at plumbing supply stores) to connect the water line to the refrigerator OR you can cut off the flared fitting with a tube cutter and then use a compression fitting. Do not cut formed end from GE SmartConnect ™...
NOTE: Be sure there is sufficient extra tubing (about 8 feet [244 cm] coiled into 3 turns of about 10 ″ [25 cm] diameter) to allow the refrigerator to move out from the wall after installation. Installation Instructions (CONT.)
• We recommend installing a water filter if your water supply has sand or particles that could clog the screen of the refrigerator’s water valve. Install it in the water line near the refrigerator. If using GE SmartConnect ™ Refrigerator Tubing kit, you will need an additional tube (WX08X10002) to connect the filter.
INSTALLING THE WATER LINE PLUG IN THE REFRIGERATOR Arrange the coil of tubing so that it does not vibrate against the back of the refrigerator or against the wall. Push the refrigerator back to the wall. START THE ICEMAKER Power switch models – Set the icemaker power switch to the I (on) position.
Remove the tape and tilt the door away from the cabinet. Lift it off the center hinge pin. Set the door on a non-scratching surface with the inside up. REMOVE THE REFRIGERATOR DOOR Tape the door shut with masking tape. Remove the center hinge pin with a 3/4″ socket.
REVERSING THE DOOR SWING TRANSFER BOTTOM HINGE BRACKET TO THE LEFT Remove the base grille by pulling it straight out. Using a socket driver, move the bottom hinge bracket from the right side to the left side. NOTE: If the washer is not on the hinge bracket, check to see if it is stuck to the bottom of the door.
Installation Instructions TRANSFER REFRIGERATOR DOOR HANDLE TO THE RIGHT To remove the handle: Remove the plug button by carefully prying under the edge with a putty knife. Remove the exposed screw holding the handle. Handle Plug Remove the two screws holding the handle to the top of the door.
Installation Instructions (CONT.) REHANG THE REFRIGERATOR DOOR Lower the refrigerator door onto the bottom hinge pin. Straighten the door and line it up with the center hinge bracket. Reinstall the center hinge pin with a 3/4″ socket.
This happens when the refrigerator is first plugged in, when the doors are opened frequently or when a large amount of food is added to the refrigerator or freezer compartments. If either door is open for over 3 minutes, you may hear the fans come on in order to cool the light bulbs.
What To Do • Wait about 40 minutes for defrost cycle to end. • Move the refrigerator and freezer control to a temperature setting. • Push the plug completely into the outlet. •Replace fuse or reset the breaker.
•See About the controls. • Call a plumber. • Foods with strong odors should be tightly wrapped. • Keep an open box of baking soda in the refrigerator; replace every three months. • See Care and cleaning. • Replace fuse or reset the breaker.
Unit just plugged in. equal to Set temperature Door open for too long. (on some models) Warm food added to refrigerator. • Allow 24 hours for system to stabilize. Defrost cycle is in process. What To Do •See Installing the water line.
This system has been tested according to NSF/ANSI 42/53 for reduction of the substances listed below. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSI 42/53.* (100% safety factors built in for unmetered usage) Parameter USEPA...
Trademark/Model Designation GE GSWF Manufacturer: General Electric Consumer Products The water treatment device(s) listed on this certificate have met the testing requirements pursuant to Section 116830 of the Health and Safety Code for the following health related contaminants: Microbiological Contaminants and Turbidity Cysts Turbidity Organic Contaminants...
CONSUMER WARRANTY Your refrigerator is warranted to be free of defects in material and workmanship. What is covered How Long Warranted (From Date of Sale) Compressor: GE Profile Models GE Models Sealed System (including evaporator, condenser tubing and refrigerant) All Other Parts...
GE Will Replace: One Year Any part of the refrigerator which fails due to a defect in materials or workmanship. From the date of the During this full one-year warranty, GE will also provide, free of charge, all labor and original purchase in-home service to replace the defective part.
Consumer Support. GE Appliances Website Have a question or need assistance with your appliance? Try the GE Appliances Website 24 hours a day, any day of the year! For greater convenience and faster service, you can now download Owner’s Manuals, order parts, catalogs, or even schedule service on-line.