Tv + Satellite Receiver + Vcr - GE HDTV Monitor User Manual

Hdtv monitor
Table of Contents

Advertisement

TV + Satellite Receiver + VCR

1. Connect your VCR to your TV.
A. Connect a coaxial cable to the VCR's antenna output jack and to the ANTENNA/CABLE
Input jack on the TV.
B. Connect the audio (white and red) cables to the VID2 L/MONO and R audio input jacks on
the back of the TV and to the audio output jacks on the VCR.
C. Connect the video cable to the VID2 V (Video) jack on the back of the TV and to the video
output jack on the VCR.
2. Make sure cable or antenna is connected to your VCR.
Connect the coaxial cable from your cable outlet or antenna to the antenna input jack on the
VCR.
3. Connect your satellite receiver's audio signal to your TV.
Connect the audio (white and red) cables to the VID1 L/MONO and R audio input jacks on
the back of the TV and to the audio output jacks on the satellite receiver.
4. Connect your satellite receiver's video signal to your TV.
A. Connect the video cable to the VID1 V (Video) input jack on the back of the TV and to the
video output jack on the satellite receiver.
– OR –
B. If your satellite receiver has an S-Video jack, connect an S-Video cable (instead of the video
cable in step B) to the S-VIDEO input jack on the TV and to the S-VIDEO output jack on
the satellite receiver.
Chapter 1
Connections & Setup
Go to page 14
9

Advertisement

Table of Contents
loading

Table of Contents