Omron POWLI BU60RE Instruction Manual page 7

Safety precautions
Do not connect devices such as dryers, some solenoid valves, etc.,
which have a half-wave rectifi er that allows only half-cycle AC power to
fl ow through.
Overcurrent may damage the UPS.
Connect the unit to a wall outlet (commercial power) with the appropriate
capacity (7.5 A or greater for BU60RE and 12 A or greater for BU100RE).
Otherwise, the power cord may be heated.
When equipment with the maximum output capacity is connected, a maximum current of 7.5 A
(BU60RE) or 12 A (BU100RE).
Provide secure grounding.
After checking the plug shape of the wall outlet, directly connect the AC input plug of the unit to it. A
failure or leak that occurs when the unit is not properly grounded may result in electric shock.
Do not disassemble, repair, or modify the unit.
Doing so may cause an electric shock or a fi re.
Do not install the unit in other than specifi ed orientations.
Dropping or toppling the unit may cause injury.
If you install the unit in an orientation other than specifi ed, the unit cannot be protected from a
battery fl uid leakage.
Use the included vertical stand when positioning the unit vertically.
Do not use the unit where the maximum temperature exceeds 55°C.
The battery deteriorates rapidly.
Doing so may cause a failure or malfunction of the unit.
Do not exceed the ranges specifi ed for environmental conditions during
use/storage.
Do not install or store the unit in the places listed below.
Do not store in places where the humidity is lower than 10% or higher than 90%.
Do not use the unit in places where the ambient temperature is lower than -10°C or higher than
55°C. (With no condensation)
Do not use in places where the humidity is lower than 10% or higher than 90%.
Do not install/store the unit in closed places such as cabinets with no clearance, places where
there is fl ammable or corrosive gas, places with large amounts of dust, places exposed to direct
sunlight, places exposed to shock or vibration, or outdoors.
Installation or storing the unit in such a place may cause a fi re.
Do not connect equipment that exceeds the output capacity of the unit.
You can use plug strip to connect additional devices, but do not connect
devices that exceed the current capacity of the plug strip.
The current protection of the unit may operate, which may stop the output.
The wiring of the plug strip heats up, which may cause a fi re.
Do not pinch or sharply bend the cable.
Do not fold or knot the cable.
Doing so may cause the cable to be damaged or heated, which may cause an electric shock or a fi re.
If the cable is damaged, stop using the unit and have the cable repaired.
For repair, contact us; ____
All of the included accessories are designed to be used exclusively with
the unit. Do not use the accessories with other devices.
Doing so may compromise the safety of devices.
Do not block the air vents (front and rear).
Doing so will cause the internal temperature to rise, which may cause the unit to fail and the bat-
tery to deteriorate.
Leave at least 5 cm of space between the vent and the wall.
vi
Caution
(for installation and connection)