Checking The Operation - Omron POWLI BU60RE Instruction Manual

2-5

Checking the operation

When you fi nish connecting the unit, confi rm that the backup operation works properly.
Check that the Battery Mode is performed normally according to the following procedure.
(In this operation check, the effects of a power failure are reproduced by disconnecting the AC input
plug from the wall outlet (commercial power).)
(1) Turn ON the unit's power switch.
The beeper sounds and the current settings are displayed on the LED.
After a few seconds, secounds, the self-diagnostic test is performed in Battery Mode for approxi-
mately 10 seconds.
When the self-diagnosis test fi nishes normally, the unit's operation switches to commercial power
and the status indication below is displayed.
(When the battery voltage is low, the self-diagnostic test is not performed and output begins
immediately via commercial power.)
(2) Bring all the connected devices into operation.
(Including devices connected to the AC outlet of your PC.)
Status indicator
Power switch "ON"
Operating normally
The unit was charged before shipment, but it may have
self-discharged during shipment, resulting in a reduced
backup time. We recommend charging the unit before use.
(3) Under this condition, check the the unit's LED display and beep sound.
Are they in the same status as shown below?
Status indicator
Beep
Power supply output receptacles
If the same as the one shown above: → The operation is normal. Proceed to (4).
If not the same as the one shown above: → The operation is abnormal. One of the cases described in
(4) Disconnect the unit's AC input plug from the wall outlet (commercial power).
The unit enters Battery Mode.
Description
Outputs power (connected devices are powered)
"4. Display and beeps when there is an equipment failure"
of "3-3 Interpreting a beep and displays" on page 23 must
apply.
Take necessary measures and then proceed to (4).
BU
ON←
None
60 100
RE/BU RE
2
15