Fm Reception; Ipod - Yamaha PianoCraft MCR-750 Owner's Manual

TROUBLESHOOTING
Problem
There is noise
interference (e.g. hiss,
crackle or jitter).
The DAB station
information does not
appear or is
inaccurate.

FM reception

Problem
FM stereo reception is
noisy.
The desired station
cannot be tuned into
with the automatic
tuning method.
The preset selecting
function does not
work.
There is distortion,
and clear reception
cannot be obtained
even with a good FM
antenna or an outdoor
antenna.

iPod

Note
In case of a transmission error without a status message appearing on the front panel display of this unit, check the connection to your
iPod (refer to page 11).
Status message
READING
UNKNOWN
STOP
NO iPod
46
En
Cause
The indoor DAB/FM antenna needs to
be repositioned.
The DAB signals are too weak.
The DAB station is temporarily out of
service, or the DAB station information
is not provided by the DAB broadcaster.
Cause
The antenna is connected improperly.
The characteristics of FM stereo
broadcasts cause this problem when the
transmitter is too far away or the
antenna input is poor.
The signal is too weak.
The preset (memory) has been erased.
Multipath reflection or other radio
interference has occurred.
Cause
This unit is in the middle of recognizing
the connection with the iPod.
There is a problem with the signal path
from the iPod to this unit.
The iPod being used is not supported by
this unit.
The iPod software is out of date.
The play back of the iPod is finished.
For example, all the songs in the
selected album have finished being
played back.
The iPod was disconnected from this
unit.
Remedy
Readjust the position of the indoor DAB/FM
antenna.
Use the TUNE AID feature to locate the best
positioning of the indoor DAB/FM antenna and this
unit for optimal DAB reception.
Contact the DAB broadcaster.
Remedy
Check the antenna connections.
Try using a high-quality directional FM antenna.
Switch to monaural mode.
Use a high-quality directional FM antenna.
Use the manual tuning method.
Preset radio stations again.
Change the height, direction, or placement of the
antenna.
Remedy
If the message continues to appear on the front panel
display and playback does not start, connect the iPod
again.
Connect the iPod again.
Only iPod classic, iPod nano (2nd, 3rd, 4th, 5th and
6th generation), iPod touch (1st, 2nd, 3rd, and 4th
generation), iPhone, iPhone 3G/3GS, iPhone 4, and
iPad are supported.
Update the iPod software version to the latest.
Connect the iPod and this unit by a USB cable
correctly.
Page
10
30
—
Page
10
—
28
—
28
28
—
Page
—
11
11
—
11