Table of Contents
Advertisement
ICFDV Fireplace Insert
Before you begin - This unit is supplied with six (6) ceramic fiber logs. Do not handle these logs with
your bare hands. Always wear gloves to prevent skin irritation from ceramic fibers. After handling
the logs, wash your hands gently with soap and water to remove any traces of fibers.
The positioning of the logs is critical to the safe and clean operation of this heater.
Sooting and other problems may result if the logs are not properly and firmly posi-
tioned in the appliance. Never add additional logs or embellishments such as pine
cones or vermiculite to the heater. Only use the logs supplied with the unit.
Failure to position the parts in accordance with diagrams below or to use only parts
specifically approved for this heater may result in property damage or personal
injury.
INSTALL LOGS AND ROCK WOOL (eMBeR MATeRIAL) IN FIReBOx
1. Break up rock wool (ember material) into small fluffy pieces. Place evenly as shown. Do not exceed
1" layer covering all round burner ports. Refer to Figures 15 and 16.
2. Apply a light layer of embers to the ports. NOTe: Excessive amount of embers will affect the flame
and the flame appearance.
Do not use the entire bag
of rock wool to cover
burner area.
Figure 15 -
Ember Material Area
Ember Material
Figure 16 -
Place Ember Material
18
LG1116
ICFDV ember material
Ember Material Area
Fp2961
ember material area
LG1116
LOG pLACeMeNT
FP2961
20304164
Hide quick links:
Advertisement
Table of Contents
