Table of Contents
Advertisement
setup screen
To configure the Ip settings
1.
Select <Basic> - <Ip>.
The IP setup window appears.
IP configuration : Set the IP and port
settings for the camera.
-
IP type : Select one from <Static
Ip>, <dynamic Ip>, and <pppoe
Ip>.
If you select <PPPoE IP>, you can
provide the optional ADSL IP and
password. However, the multicast items
(multicast address, port, TTL) for VNP
and RTP will disappear.
-
MAC address : Displays the
Ethernet MAC address.
This is used for creating a DDNS
address.
-
IP address : Displays the current IP
address.
-
Subnet mask : Displays the
<Subnet mask> for the set IP.
-
Gateway : Displays the <Gateway> for the set IP.
-
DNS server : Displays the DNS(Domain Name Service) server address.
-
HTTP webserver port : HTTP port used to access the camera via the web
browser. The default is 80(TCP).
-
Upload port (TCP) : Used to upgrade the software firmware, defaulted to 60004(TCP).
IPv6 configuration : Obtains the IPv6 address to access the IPv6 network.
VNP configuration : Set a port used to transfer video signals with the Samsung
protocols.
-
Device port (TCP) : Used to control the video signal transfer, defaulted to 60001(TCP).
-
TCP streaming port : Video signal transfer port using TCP protocols, defaulted
to 60002(TCP).
-
UDP streaming port : UDP Port used to transfer video signal with the UDP
Unicast protocols. The default is 60003(UDP).
-
Multicast address : IP address used to transfer video signal with the UDP
Multicast protocols.
The default is 225.128.1.128, and if you want to change the address, specify it
ranging from 224.0.0.0 to 239.255.255.255.
_ setup screen
Advertisement
Table of Contents
