Table of Contents
Advertisement
camera may cause personal injury.
6.
Do not place conductive objects (e.g. screwdrivers, coins, metal parts,
etc.) or containers filled with water on top of the camera. Doing so may
cause personal injury due to fire, electric shock, or falling objects.
7.
Do not install the unit in humid, dusty, or sooty locations. Doing so may
cause fire or electric shock.
If any unusual smells or smoke come from the unit, stop using the
8.
product. In such case, immediately disconnect the power source and
contact the service center. Continued use in such a condition may
cause fire or electric shock.
9.
If this product fails to operate normally, contact the nearest service
center. Never disassemble or modify this product in any way. (SAMSUNG
is not liable for problems caused by unauthorized modifications or
attempted repair.)
10.
When cleaning, do not spray water directly onto parts of the product.
Doing so may cause fire or electric shock
Do not expose the product to the direct airflow from an air conditioner.
11.
Otherwise, it may cause moisture condensation inside the Clear Dome
due to temperature difference between internal and external of the
dome camera.
12.
If you install this product in a low-temp area such as inside a cold store,
you must seal up the wiring pipe with silicon, so that the external air can
not flow inside the housing.
Otherwise, external high, humid air may flow inside the housing, pooling
moisture or vapor inside the product due to a difference between
internal and external temperature.
CAUTIoN
Do not drop objects on the product or apply strong blows to it. Keep
1.
away from a location subject to excessive vibration or magnetic
interference.
Do not install in a location subject to high temperature (over 50°C), low
2.
temperature (below -10°C), or high humidity. Doing so may cause fire or
electric shock.
3.
If you want to relocate the already installed product, be sure to turn off
the power and then move or reinstall it.
Remove the power plug from the outlet when there is a lighting storm.
4.
Neglecting to do so may cause fire or damage to the product.
5.
Keep out of direct sunlight and heat radiation sources. It may cause fire.
Install it in a place with good ventilation.
6.
7.
Avoid aiming the camera directly towards extremely bright objects such
as sun, as this may damage the CCD image sensor.
English _
Advertisement
Table of Contents
