Table of Contents
Advertisement
IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY
RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY, OR LOSS OF LIFE.
A. A. A. A. A. This appliance has a pilot which must be lit
by hand. When lighting the pilot, follow these
instructions exactly.
B B B B B . . . . . B B B B B EF
EF EF
EF EFOR
OR
OR
E LIGH
E LIGH
E LIGHT T T T T I I I I I NG,
NG,
NG,
OR
ORE LIGH
E LIGH
NG,
NG, smell all around the
appliance area for gas. Be sure to smell next
to the floor because some gas is heavier than
air and will settle to the floor.
W W W W W HA
HAT T T T T T T T T T O DO I
HA
HA
O DO I
O DO I
O DO IF F F F F Y Y Y Y Y OU S
OU S
OU S
HA
O DO I
OU SMELL G
OU S
• Extinguish any open flame.
• Open windows.
• Do not light any appliance.
• Do not touch any electrical switches.
• Do not use any phone in your building.
• Immediately call your gas supplier from a
neighbor's phone.
1. 1. 1. 1. 1. STOP! Read the safety information above.
2. 2. 2. 2. 2. Access the valve controls in the left side compartment.
3. 3. 3. 3. 3. Turn the Burner ON/OFF switch to "OFF", or set the
thermostat to the lowest setting (if used).
4 4 4 4 4 . . . . . Confirm that the gas supply line shut-off valve is open.
Control
Knob
Control Valve
5 5 5 5 5 . . . . . Push in gas control knob slightly and turn clockwise
to "OFF".
NOTE: Knob cannot be turned from "PILOT" to "OFF"
unless the knob is pushed in slightly. Do not force.
6. 6. 6. 6. 6. Wait five (5) minutes to clear out any gas. If you then
smell gas, STOP! Follow "B" in the safety information
above on this page. If you do not smell gas, go to the
next step.
1. 1. 1. 1. 1. Turn ON/OFF switch to" OFF". The pilot will remain lit for
normal service.
2. 2. 2. 2. 2. For complete shutdown, turn ON/OFF switch to "OFF".
LIGHTING INSTRUCTIONS
FOR YOUR SAFETY, READ BEFORE LIGHTING.
WARNING:
MELL GA A A A A S: S: S: S: S:
MELL G
MELL G
MELL G
LIGHTING INSTRUCTIONS
TO TURN OFF GAS TO THE APPLIANCE:
• If your gas supplier cannot be reached, call the
fire department.
C. C. C. C. C. Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob will not
push in or turn by hand, do not try to repair it.
Call a qualified technician. Force or attempted
repair may result in a fire or explosion.
D D D D D . . . . . Do not use this appliance if any part has been
under water. Immediately call a qualified service
technician to inspect the appliance and to
replace any part of the control system and any
gas control which has been under water.
7 7 7 7 7 . . . . . Push in gas control knob slightly and turn counter-
clockwise
to "PILOT".
8. 8. 8. 8. 8. Push in control knob all the way and hold in.
Immediately light the
pilot by triggering the
spark ignitor (push the
red button repeatedly)
until pilot lights.
Continue to hold the
control knob in for
about one minute after
the pilot lights. Release knob and it should spring
back. The pilot should remain lit. If it goes out,
repeat Steps 5 through 8.
• If knob does not return when released, stop and
immediately call your service technician or gas
supplier.
• If pilot will not stay lit after several attempts,
turn the control knob to OFF and call your service
technician or gas supplier.
9. 9. 9. 9. 9. Turn gas control knob counterclockwise
10 10 10 10 10. . . . . Set the Burner switch to "ON" to light the burner. If
using a thermostat, set Burner switch to "T-STAT" and
set the thermostat to the desired temperature.
3. 3. 3. 3. 3. Access the lower controls.
4 4 4 4 4 . . . . . Depress gas control knob slightly and turn clockwise
to "OFF". Do not force.
Pilot Assembly
to "ON".
31
Hide quick links:
Advertisement
Table of Contents
