Emirror Setting; Setting - Sanyo VCC-6974 Instruction Manual

USING THE MENU SCREEN
E MIRROR setting
1
Press the CURSOR (l, then d or c) button to change the MIRROR setting to "H"
(the setting will flash).
The image will be inverted horizontally. The image will change as described below each time
the CURSOR button is pressed.
•
OFF: Normal image
•
H: Inverted horizontally
2
When finished:
Press the CURSOR (l) button to select BACK (it will flash) at the bottom of the
screen. Then press the CURSOR (d or c) button to change BACK to END, and
press the SET button.
To return to the previous screen, select BACK then press the SET button.
RS-485 setting
F
1
Press the CURSOR (l) button to select the RS-485 setting "SET" (the setting will
flash), then press the SET button. The MENU FOR RS-485 screen will be displayed.
2
Press the CURSOR (l) button so that the BAUD RATE value is flashing, then press
the CURSOR (d or c) button to change the communication speed.
Note: The BAUD RATE setting should be compatible with the transmission speed of the
peripheral devices.
3
Press the CURSOR (l, then d or c) button to change the ALARM setting to ON
(the setting will flash), then set the alarm transmission.
ON: Alarm signals are sent to the controller
OFF: Alarm signals are not sent to the controller
•
V: Inverted vertically
•
HV: Inverted horizontally and vertically
OPTION/MIRROR, RS-485
OPTION MENU
CURSOR
APERTURE
AGC
GAMMA
ZOOM
MIRROR
OFF H
CURSOR
SET
MENU
MENU
OPTION MENU
CURSOR
SET
APERTURE
AGC
GAMMA
ZOOM
MIRROR
RS-485
MENU FOR RS-485
CURSOR
SET
BAUD RATE
ALARM
19200 9600 4800 2400
ON p
ON
ON
OFF
H
V HV
BACK
END
ON p
ON
ON
OFF
OFF
SET p
19200
ON
OFF
56
English