Bei (Electronic Iris) Mode Setting - Sanyo VCC-6974 Instruction Manual

USING THE MENU SCREEN
SENSE UP setting
Press the CURSOR (l) button so that the SENSE UP setting is at OFF
and is flashing, then press the CURSOR (d or c) button to set the
exposure time.
The basic exposure time is 1/60 second (SENSE UP set to OFF), and
the setting can be changed to X2, X4, X8, X16 or X32.
Note:
•
When the MOTION item is set to ON, the SENSE UP setting is not
possible.
•
When filming moving subjects, the higher the SENSE UP setting
(sensitivity), the more pronounced afterimage will be visible. Also,
when the sensitivity is high, white dots will be visible on the screen,
this is due to the CCD characteristics.
ADJUSTMENT FOR AI
CURSOR
LENS TYPE
BLC
SENSE UP
OFF X2 X4 X8 X16 X32
27
English
DC
OFF
OFF
EI (Electronic Iris) mode setting
B
The EI mode setting is the same as for the AI mode setting with a DC
type lens, please refer to page 22.
1
Press the CURSOR (l, then d or c) button until "EI" in the
IRIS item is flashing, then press the SET button.
The ADJUSTMENT FOR EI screen will be displayed.
2
Press the CURSOR (l, then d or c) button to select MULTI or
EVAL for the BLC (backlight correction) setting.
Note:
•
When the electronic iris function captures a very bright subject (such as a
light, etc.), the quantity of light entering the lens cannot be adjusted, and
image smearing and other conditions may appear. In such a case, this can
be prevented by changing the lighting angle or using an auto-iris lens.
•
The EI mode setting is used for indoors only.
•
If the camera location lighting if fluorescent, it will be scattered by the
subject. To prevent this, it is recommended to change to incandescent
lighting.
MAIN MENU
SET
LANGUAGE SET
CAMERA ID OFF
SYNC INT
IRIS EI
AI/SENSE UP•EI
ADJUSTMENT FOR EI
p
BLC
SENSE UP
p
SET
MULTI p
OFF
EVAL p
OFF