SECTION 12—BATTERIES
2. Remove the existing batteries from the battery boxes. Refer to Installing/Removing the
Batteries Into/From the Battery Boxes on page 53.
3. Clean the new battery terminals. Refer to Cleaning Battery Terminals on page 62.
4. Install the new batteries into the battery boxes. Refer to Installing/Removing the
Batteries Into/From the Battery Boxes on page 53 of this manual.
5. Install the battery boxes onto the wheelchair. Refer to Installing/Removing the Battery
Boxes on page 51 of the manual.
Installing/Removing the Battery Boxes
NEVER unplug the battery cables by pulling on the wires. Unplug the battery cables
by pulling on the connector ONLY. Otherwise injury or damage may result.
NOTE: For this procedure, refer to FIGURE 12.2.
NOTE: To remove the battery boxes from the wheelchair, reverse the following procedure.
1. Verify that the on/off switch on the joystick is in the off position.
2. Place the front battery box onto the battery tray and connect controller connector to
the front battery box.
3. Slide front battery box toward the front of the wheelchair.
4. Place rear battery box onto the battery tray and connect the rear battery box to the
front battery box.
5. Connect the front battery box to the controller.
The battery box retaining strap MUST be fastened securely and adjusted properly
to hold battery boxes in place before using the wheelchair.
6. Connect the battery box retaining strap clip together and adjust if necessary.
Nutron® Series
WARNING
WARNING
51
Part No.1106645