SECTION 5—WHEELCHAIR OPERATION
SECTION 5—WHEELCHAIR
OPERATION
After ANY adjustments, repair or service and BEFORE use, make sure that all
attaching hardware is tightened securely - otherwise injury or damage may result.
Set-up/programming of the Electronic Control Unit is to be performed ONLY by a
qualified technician. The fine tuning adjustments of the controller may affect other
activities of the wheelchair. Damage to the equipment could occur under these cir-
cumstances. IF UNQUALIFIED INDIVIDUALS PERFORM ANY WORK ON
THESE UNITS, THE WARRANTY IS VOID.
Operating the Wheelchair
Turning the Power On/Off
NOTE: For this procedure, refer to FIGURE 5.1.
1. Turn the power on by moving the on/off switch up or down. The switch automatically
retracts back to center position.
NOTE: After turning power on, all indicators
will light briefly, and the display gauge will
indicate one of the following:
A. The Current Battery Charge ‐
Information gauge shows all LEDʹs lit
or partial LEDʹs lit.
B. Out Of Neutral at Power Up ‐
Information Gauge shows all LEDʹs
flashing slowly. This occurs when the
power is turned on when the joystick is
out of neutral. This feature prevents
sudden and unexpected movements of
the power chair.
2. Turning the power off can be achieved
by moving the on/off switch up or
down. The switch automatically
retracts back to center position.
Nutron® Series
WARNING
FIGURE 5.1 Operating the Wheelchair
27
Information
Gauge
INVACARE
On/Off
Toggle
Switch
Part No.1106645