4. Pull the loose back canes out of the existing back upholstery.
5. Slide the loose back canes into the new back upholstery.
6. Secure the back canes to the wheelchair frame with the mounting screws and locknuts
removed in STEP 1.
7. Secure the new back upholstery to the back canes with the two (2) existing upholstery
mounting screws and washers.
Washer
Upholstery
Mounting
Screws
Replacing Seat Positioning Strap
NOTE: For this procedure, refer to FIGURE 9.3.
1. If necessary, remove the seat cushion from the seat upholstery.
2. Remove the two (2) rear phillips screws and washers that secure the seat upholstery
and seat positioning strap to the crossbraces.
3. Remove the two (2) halves of the seat positioning strap from the crossbraces.
4. Position the two (2) new seat positioning strap halves between the seat upholstery and
the crossbraces.
5. Reinstall the rear phillips screws and washers that secure the seat upholstery and seat
positioning strap to the crossbraces.
NOTE: Washer is positioned on top of seat upholstery.
6. If necessary, reinstall the seat cushion onto the seat upholstery.
Part No.1106645
SECTION 9—UPHOLSTERY/SEAT POSITIONING STRAP
Back Upholstery
Locknuts
FIGURE 9.2 Replacing Back Upholstery
NOTE: All four (4) mounting
screws and locknuts are shown.
Each fold‐down back cane uses
two (2) mounting screws.
Back Cane
44
Mounting Screws
Wheelchair Frame
Nutron® Series