SECTION 6—FRONT RIGGINGS
Model 93M, 904A, PAL4A, and PAS4A Footrests
NOTE: For this procedure, refer to FIGURE 6.3.
1. Loosen, but do not remove the lug bolt and locknut that secure the lower footrest to
the footrest support.
2. Reposition the lower footrest to the desired height.
3. Securely tighten the lug bolt and locknut that secure the lower footrest to the footrest
support.
4. Repeat STEPS 1‐3 for the other footrest, if necessary.
NOTE: 93M style footrest shown. 904A, PAL4A and PAS4A footrests adjust the same way.
FIGURE 6.3 Adjusting the Footrest Height - Model 93M, 904A, PAL4A, and PAS4A Footrests
Replacing Heel Loops
NOTE: For this procedure, refer to FIGURE 6.4.
1. Note the position of hex bolt, coved
washers and locknut for reinstallation.
2. Remove the hex bolt, coved washers
and locknut that secure the lower
footrest to the footrest support.
3. Remove the lower footrest.
4. Remove the phillips bolt, spacer and
locknut that secure the existing heel
loop to the lower footrest.
5. Slide the existing heel loop off the
lower footrest.
6. Replace heel loop.
7. Reverse STEPS 1‐6 to reassemble.
NOTE: When securing heel loop to lower footrest, tighten the phillips screw and locknut until the
spacer is secure.
Nutron® Series
Locknut
Locknut
Coved
Washers
Lower Footrest
FIGURE 6.4 Replacing Heel Loops
33
Lug Bolt
Footrest Support
Lower Footrest
Footrest Support
Hex Bolt
Phillips Bolt
Locknut
Spacer
Heel Loop
Part No.1106645