Toshiba E-Studio 2330c Troubleshooting Manual page 62

1 TROUBLESHOOTING FOR THE HARDWARE
4
Remove the empty staple cartridges.
Replace both cartridges at a time.
5
Fit the new cartridges.
Insert each cartridge until it is caught by the latch and is fixed with a
click.
6
Unlock the stapler of the Saddle Stitch unit by pulling
its handle toward you, and lower the stapler to its
original position.
7
Slowly insert the Saddle Stitch unit into the Finisher.
8
Make sure that the following two requirements are met before test stapling:
The Finisher is securely attached on the equipment.
A3, B4, A4-R, LD, or LT-R paper is loaded in the drawer
When the message "Check staple cartridge in the Saddle Stitch unit" is displayed, this step is unnecessary.
Proceed to step 9.
60 Refilling With Staples
2
1