Service Indicator Error Codes - Invacare Lynx L-4 User Manual

14 TROUBLESHOOTING

14.2 Service Indicator Error Codes


For the following table, refer to
FLASH DESCRIPTION
1
Battery Low
2 Low Battery Fault
3 High Battery Fault
4
Current Limit Time-out
5 Park Brake Fault
6
Throttle OONAPU
7 Speed Pot Fault
8 Motor Voltage Fault
9
Other error
10
Push/Rollaway Fault
Lynx™L-3 & Lynx L-4 Scooters
FIGURE 6.1 on page 25.
MEANING
The batteries are running low.
• Recharge the batteries.
The batteries have run out of charge.
• Recharge the batteries.
Battery voltage is too high. This may occur if overcharged &/or traveling down a long slope.
• If traveling down a slope, reduce your speed to minimize the amount of regenerative charging.
• Check the battery and associated connections and wiring.
The motor has been exceeding its maximum current rating for too long. This may be due to a faulty motor.
• Check the motor and associated connections and wiring.
• Turn the controller off, leave for a few minutes and turn back on again.
Either a park brake release switch is active or the park brake is faulty.
• Check the park brake and associated connections and wiring.
• Ensure any associated switches are in their correct positions.
The Throttle is out of neutral when turning the controller on.
• Ensure the throttle is in neutral when turning the controller on.
• The Throttle may require re-calibration.
The throttle, speed limit pot, SRW or their associated wiring may be faulty.
• Check the throttle and speed pot and associated connections and wiring.
The motor or its associated wiring is faulty.
• Check the motor and associated connections and wiring.
The controller may have an internal fault.
• Check all connections & wiring.
The scooter has exceeded the Push or Rollaway speed limits.
• Turn the controller off and then on again.
54
Part No. 1143205