Error Codes And Diagnostic Codes - Invacare Colibri User Manual

Invacare® Colibri

10.1.2 Error codes and diagnostic codes

Flash code Fault
1
Batteries must be
charged
2
Battery voltage too low
3
Battery voltage too high
4
Power time exceeded
44
Consequence for the
scooter Comments
Continues to drive •
Stops driving •
•
Stops driving •
•
Stops driving •
•
•
The batteries are discharged. Charge the batteries as
soon as possible.
The batteries are depleted. Charge batteries.
If you switch the scooter off for a few minutes, the
batteries can often recuperate to such a stage that a
short journey is still possible. You should only do this
in an emergency, however, because this causes the
batteries to become excessively discharged.
The battery voltage is too high. If the battery charger
is connected, disconnect it from the scooter.
The electronic system charges the batteries when
running downhill and when braking. This fault is
caused when the battery voltage becomes too high
during this process. Switch the scooter off and on
again.
The maximum current was exceeded over too long a
period, probably because the motor was overloaded
or has been working against an immovable resistance.
Switch the scooter off, wait a few minutes and then
switch on again.
The electronic system has determined a motor
short-circuit. Check the wiring harness for short-circuit
and check the motor.
Contact your Invacare provider.
1576371-C