How To Clean The Motor Filter; How To Replace The Brushes - Alto Filtra-Vac 14 Operator's Manual

Figure 18
Figure 19
Page 24

How To Clean The Motor Filter

Clean the motor filter whenever it is dirty. To clean the
motor filter, follow this procedure:
1. Open the tank assembly.
2. Remove the filter bag.
3. Pull the filter cover off the filter disc.
4. Remove the filter.
5. Wash the filter in water.
6. Put the filter in a cloth and apply pressure to dry
the filter.
7. Put the filter in the filter cover.
NOTE: Install the filter cover with the opening
toward the back of the tank housing. See
figure 18.
CAUTION: Check the motor protection filter
while changing the paper bag. Please change
the motor protection filter after use of 6 paper
bags.
8. Install the filter bag.
9. Close the tank assembly.

How To Replace The Brushes

1. Put the machine on its side.
2. Turn the knobs which secure the nozzle plate.
See figure 19.
3. Remove the nozzle plate.
4. Remove the brush assembly.
5. Install the new brush assembly.
6. Install the nozzle plate, and screws.
7. Put the machine on its wheels.
WARNING: To reduce the risk of injury from
moving parts, unplug before servicing.
ATTENTION: Pour ériter d'être blessé pour les
piéces en mouvement, débiancher avant la
maintenance.
Filtra-Vac 14 and 18 Operator's Manual
CLARKE TECHNOLOGY