Turning The Scanner On; Power Save Mode - Fujitsu fi-4530C Operator's Manual

1.1

Turning the Scanner ON

1. Press the power button on the operator panel.
The scanner is turned ON, and the green LED on the operator panel lights.
During the initialization, the indication of the Function No. display changes as follows:
"8"->"P" -> "0" -> "1"
The indication "1" means that the operator panel is in the ready status.
HINT

■ Power Save Mode

The Power Save mode keeps the scanner in a low-powered state if no operation is performed on the
scanner for 15 minutes after it has been turned ON. The scanner is automatically switched to the
Power Save mode.
In the Power Save mode, the indication of the Function No. display on the operator panel goes out,
while the green LED is kept lit.
To return the scanner from the Power Save mode, perform one of the following operations:
• Load documents on the ADF paper chute.
• Press any button on the operator panel.
The scanner will be turned OFF when pressing down the power button for two seconds.
• Execute a command from the scanner driver.
2
To turn the scanner OFF, hold the power button down for two seconds.
Power button