Fujitsu fi-4530C Operator's Manual page 101

Symptom 3
Are the documents loaded correctly
on the ADF paper chute?
Is the ADF closed completely?
Is the interface cable connected
correctly?
(when using the scanner on SCSI
interface)
Is the SCSI ID set correctly?
Does the Function No. display
indicate any alarm?
Does the alarm state remain
displayed even after the scanner
has been turned off and on again?
Contact the manufacturer's
authorized service center.
86
The scanning does not start.
NO
YES
NO
YES
NO
YES
NO
YES
NO
YES
NO
YES
Load the documents correctly
on the ADF paper chute.
Remove all documents from
the ADF paper chute. Then
open and close the ADF.
Connect the interface cable
correctly.
Set the SCSI ID correctly by
the SCSI ID switch on the
rear side of scanner.
The scanner operation is
normal.
The scanner operation is
normal.