Table of Contents
Advertisement
CLEANING AND MAINTENANCE
BURNER CLEANING
1. Wire brush entire surface of burner to remove food
residue and dirt.
2. Clean any clogged ports with a stiff wire such as an
open paper clip.
3. Inspect the burner for damage (cracks or holes) and if
such damage is found, order and install a new burner.
After installation check to insure the gas valve orifices
are correctly placed inside the ends of burner tubes.
Also check the position of the spark electrode.
CLEANING THE GREASE TRAY
The grease tray should be emptied and wiped done
periodically and washed in a mild detergent and warm water
solution. A small amount of sand or cat litter may be placed
in bottom of grease try to absorb the grease
ANNUAL CLEANING OF GRILL HOUSING
Burning-off the grill after every cook out will keep it ready for
instant use; however once a year minimum you should give
the entire grill a thorough cleaning to keep it in tip operating
condition
INTERIOR:
1. Turn the burner valve off.
2. For NG turn the safety valve to off
3. Remove and clean the cooking grids, flame tamers.
4. Brush the inside and bottom of the grill with a stiff wire
brush, and wash down with a mild soap and warm water
solution. Rinse thoroughly and let dry.
5. Check spark electrode, adjusting as instructed.
Electrode tip pointing toward the tip of gas collector and
approximately 3/16" from the tip of collector tube
6. Replace flame tamers cooking grids.
7. Reconnect to the gas source and observe the burner
flame for correct operation.
IMPORTANT:
You should NOT line the bottom of the grill housing with
aluminum foil, sand or any other grease-absorbent
substance. Grease will not be able to drip down into grease
collector and a grease fire could occur.
EXTERIOR:
Your Charmglow grill is made of heavy stainless steel; it
should provide you with years of trouble-free service
CLEANING THE COOKING GRIDS
After cooking, turn control knobs to "OFF" and let grill
cool before attempting to clean your cooking grids.
Before first use and periodically it is suggested that you
wash the cooking grids in a mind soap and warm water
solution. You can use a washcloth, a vegetable brush or
a steel wool to clean your cooking grids if you desire.
CLEANING THE FLAME TAMER
Washing the flame tamer after every use is not necessary
but periodically it is suggested you wash the tamer in a
soap and warm water solution. Use a wire brush to
remove stubborn burnt on cooking residue. Dry the flame
tamer thoroughly before you re-install into the grill
housing.
CLEANING THE BURNER TUBES AND BURNER
PORTS (TO PREVENT FLASH-BACK) SPIDER AND
INSECT WARNING!!!
Spiders and insects can nest in the burners of this or any
other grill, and cause the gas to flow from the front of the
burner. This is a very dangerous condition, which can
cause a fire to occur behind the valve panel (flash back),
thereby damaging the grill and making it unsafe to
operate. We recommend that you inspect for spiders
regularly in late summer or early fall when they are most
active.
To inspect for spiders:
1. Turn the burner valve off.
2. Turn the gas supply off fully (Turn clockwise to stop).
3. Remove cooking grids, flame tamers.
4. Unscrew and remove the burners from the grill
housing.
5. Carefully lift each burner up and away from gas valve
orifice. Inspect for any obstructions ands use air
pressure or a clean plastic brush to clear the burner
tube or any debris.
6. Carefully replace the burner in its exact position
directly in front of gas valve orifice.
.
15
K15Y06N-1
Advertisement
Table of Contents
