Viglen BX130 User Manual page 68

Power LED
The Power LED connector is located on pins 15 and 16 of JF1. This connection is
used to provide LED indication of power being supplied to the system. See the below
for pin definitions.
HDD LED
The HDD LED connection is located on pins 13 and 14 of JF1. Attach the hard drive
LED cable here to display disk activity (for any hard drives on the system, including
SCSI, Serial ATA and IDE). See the table below for pin definitions.
Overheat LED (OH)
Connect an LED to the OH/Fan Fail connection on pins 7 and 8 of JF1 to provide
advanced warning of chassis overheating or system fan failure. Refer to the table
below for pin definitions.
Power Button
The PW_ON connector is located on pins 1 and 2 of JF1. Connect it to the chassis
power button, which you may also configure to put the system into suspend mode
(see the Power Button Mode setting in BIOS). To turn off the power when the
suspend mode is enabled, depress the power button for at least 4 seconds. See the
table on the right for pin definitions.
67
Viglen BX130 – VIG385P User Manual