Viglen BX130 User Manual page 38

Application
software problems
Hard drive light
does not go on
when drive is in use
or is tested by
POST
Power-on light does
not go on
Prompt doesn't
appear after system
boots
Setup, can't enter
System halts before
completing POST
1. Make sure all cables are installed correctly.
2. Verify that the system board jumpers are set properly.
3. Verify that your system hardware configuration is set correctly. In
Setup, check the values against the system settings you recorded
previously. If an error is evident (wrong type of drive specified, for
example), make the change in Setup and reboot the system.
Record your change.
4. Make sure the software is properly configured for the system. Refer
to the software documentation for information.
5. Try a different copy of the software to see if the problem is with the
copy you are using.
6. If other software runs correctly on the system, contact the vendor of
the software that fails.
7. If you check all of the above with no success, try clearing CMOS
RAM and reconfiguring the system. Make sure you have your list of
system settings available to re-enter, because clearing CMOS RAM
sets the options to their default values.
1. Make sure the power and signal cables for the drive are properly
installed.
2. Make sure the front panel connector is securely attached to the
system board headers.
3. Check that the drive is properly configured and enabled in Setup.
4. Check the drive manufacturer's manual for proper configuration for
remote hard disk drive activity.
If the system is operating normally, check the connector between the
system board and the front panel. If OK, the light may be defective.
A serious fault may have occurred consult your Viglen Technical
Support.
If you can't enter Setup to make changes, clear CMOS RAM to the
default values and reconfigure the system in Setup.
This indicates a fatal system error that requires immediate service
attention. Note the screen display and write down any beep code
emitted. Provide this information to your Viglen Technical Support.
Viglen BX130 – VIG385P User Manual
37