Viglen BX130 User Manual page 20

PCI Auto Configuration
The PCI auto -configuration utility works in conjunction with the Set-up program to
support using PCI add-in boards in the system. When you turn on the system power
after installing a PCI board, the BIOS automatically configures interrupts, DMA
channels, I/O space, and so on. Since PCI add-in boards use the same interrupt
resources as ISA add-in boards, you must specify the interrupts used by ISA boards
in the set-up program. The PCI auto-configuration program complies with version 2.1
of the PCI B IOS specification.
IDE Auto Configuration
If you install an IDE drive in the system, the IDE auto-configuration utility
automatically detects and configures the drive for operation in the system. This
utility eliminates the need to enter the Set-up program after you install an IDE drive.
Expansion Slots
The system has four PCI bus add-in card connectors and One AGP universal
connector.
?
One (1) PCI-Express x16 (intended for graphics)
?
One (1) PCI-Express x8 (PCI-Express x1 Signal)
?
One (1) PCI-Express x1
?
Four (4) 32-bit PCI 33MHz (5V)
Viglen BX130 – VIG385P User Manual
19