Network Configuration By Hyper Terminal - Eneo FNR-4016/500 User Manual

2.2 Network Configuration by Hyper Terminal

Enter Hyper Terminal
Click "Start"->"Programs"->"Accessories"->"Communications"->"Hyper Terminal"->"HK", then the Hyper Terminal
interface will appear as figure below. Type "Enter", and the prompt "[root@dvrdvs/]#" will appear which means
connection between RS232 interface of PC and RS232 interface of NVR is established successfully by Hyper Terminal.
The following operation commands are to accomplish the parameters setup in the prompt.
Figure 2.2.1
Commands Utilities
helpm Console help command is used to print common commands, show as Figure 2.2.1.
getIp Show the current IP address of NVR. Command format: getIp "Enter".
Setup NVR IP address. Command format: setIp IP: mask
setIp
e.g. setIp 192..168.1.11:255.255.255.0
getPort Show the current port of NVR. Command format: getPort "Enter".
Setup NVR port. Command format: setPort Port
setPort
e.g. setPort 9000
getGateway Show current NVR gateway address. Command format: getGateway "Enter".
Setup NVR gateway. Command format: setGateway Gateway
setGateway
e.g. setGateway 192.168.1.1
11