Citizen OPTICAL MOUSE User Manual page 33

Top Menu Sub Menu
Function Select
Cutter Action
Paper Position
Mode/Repeat Key
Interfaces RS-232C Baud
RS-232C Parity
RS-232C Length
RS-232C Stop bit
RS-232C X-ON
IEEE1284
* Effective only when the optional unit is attached.
Default
Tear
*
Backfeed
0.00IN
0.00mm
Disabled
9600
None
8 bits
1 bit
Yes
ON
33
Menu Remarks
Off ...... Auto configure ineffective.
Selects the type of options installed and
Off
adjusts the "paper stop" position accordingly.
Tear
*
For example, the position where the label stops
Peel On
*
in "Tear" mode is different to that in "Peel On"
Cut On
mode.
Backfeed Cutter operating method setting
Through Backfeed: it feeds back after each cutting
operation.
Through: when the number copied = n, the
back end of sheet 1 to n-1 passes through,
and the back end of the final page that is a
single sheet is copied and fed back.
Peel/Cut/Tear Off
The stop position can be fine tuned using this
0.00 to 2.00 IN
menu setting. The general stop position is
0.0 to 50.8mm
selected depending on the "Function" selected
Peel/Cut/Tear On
above.
-1.00 to 1.00 IN
-25.4 to 25.4mm
LabelSet Repeat method selection
LastOne LabelSet:
Disabled
Reissues multiple labels.
LastOne:
Issues only the final page.
In count case, it issues only 1 label while
continuing.
Disabled:
Makes the repeat key invalid.
1 15200
Sets the baud rate of the serial interface.
57600
• Interface related settings are effective after
38400
the power is turned on again.
19200
9600
4800
2400
None Sets the communication parity of the serial
Odd interface.
Even
8 bits Sets the character length of the serial interface.
7 bits
1 bit Sets the stop bit of the serial interface.
2 bits
Yes Selects the X-ON flow control of the serial
No interface.
ON Enable or disables the 'enhanced' features of
OFF the IEEE1284 parallel interface.
Printer Operation
Mode Settings
When a peeler unit or auto-cutter is
installed but has not been started, it
is off and the operation is selected
by "Function select".