Intel EXPRESS 550T User Manual page 138

C H A P T E R 8
Commands allowed in
Maintenance Mode
bootptab file entry
128
Console Port Use and Troubleshooting
The following command is available for the switch in Maintenance
Mode:
Command Use
TFTP <filename> ownIP tftpIP [gwIP]
Loads software using the TFTP protocol
<filename>
the software
ownIP : your own IP address
tftpIP : the IP address of the TFTP host
[gwIP: the IP address of the primary router
(intermediate gateway)— required if the TFTP
server is located on a remote part of the network
BOOTP <filename>
Loads software using the BOOTP or TFTP pro-
tocol
<filename>
the software
Dumps memory contents
DUMP addr
Shows hardware information
INFO
Resets the switch
RESET
Starts the software in its default factory settings
RUN defparm
The entry for the switch in the bootptab should contain a line sim-
ilar to:
:bf=/intel/switch/es550_x.xx:
This instructs the switch to load the switch software from the bootp/
tftp server. Use the Intel Device View application to configure the
switch manually, or transfer the inxxxxxx.p file containing the con-
figuration from a TFTP server to the switch.
: the name of the file containing
: the name of the file containing