C H A P T E R 3
Changing the forward
delay expiry time
Changing the state of the
ports
Purpose
Standard Configuration
5
Click OK .
To change the time between port states while the bridge attempts to
become the root:
1
Select Device Setup or Stack Setup .
2
Click Spanning Tree .
3
Click Forward Delay Timer Expiry .
4
Type the required number of seconds.
5
Click OK .
To specify that all ports are using Spanning Tree Protocol:
1
Select Device Setup or Stack Setup .
2
Click Spanning Tree .
3
Click Enable All Ports .
The ports are able to resolve problematic network loops using
STP.
4
Click OK .
Changing the Setup of the
Port
You can configure the port to operate in different ways, according to
your network's requirements:
Change the port state
•
Select the auto-negotiation mode
•
Change each port to half or full duplex
•
(If auto-negotiation is not enabled)
•
Specify the speed of the port
(If auto-negotiation is not enabled)
•
Change the forwarding mode of the port
•
Change the flow control setting of the port
57