Power-Up Screen
•
This screen is displayed only on power up, first use de-
fault and factory default.
•
st
The 1
upper right corner number displays the base's soft-
ware revision. The single version number increments for
changes in operational software.
•
nd
The 2
upper right corner number displays the base's
channel map (frequency plan) version. The single version
number increments for changes in the channel map.
•
Once the power-up screen is displayed, it will change to
the operating screen after a few seconds.
Operating Screen
•
Screen is displayed after power-up screen.
•
System will revert to this screen if no activity is detected
on the LCD display buttons after 3 minutes.
•
Screen displays current status of the system.
Beltpack Activity Code Definitions:
no tx = No Beltpack Transmit Carrier Detected
Off
= Receiver is not selected on front panel
Ch A = Beltpack audio is on Channel A
Ch B = Beltpack audio is on Channel B
TA A = Beltpack Channel B Talk Around Active
TA B = Beltpack Channel A Talk Around Active
SA
= Beltpack Stage Announce Active
Power-Up Screen
Telex
RadioCom
Operating Screen
Group 03A
T1
On
T1
2
On
6-5
SB10001
C60001
TM
tx
R1
no
2
Off
3
Ch B
4
TA A