Telex RadioCom BTR-800 Operating Instructions Manual page 47

Receive 2 Screen
The Receive 2 screen allows the user to set the beltpack re-
ceive 2 frequency. This corresponds to the base station's trans-
mit 2 frequency. In factory-defined groups receive 1 is not
changeable. User-programable groups will allow the user to
change the frequency in 25 KHz steps.
•
Press [MENU] three times from the group/channel screen
to arrive at the receive 2 frequency screen.
•
(User-Programmable Groups Only) Press [SET] to edit
the frequency. The number will start flashing. Fac-
tory-defined groups can't be changed, so pressing set will
do nothing at this screen. User-programmed groups will
start flashing and allow the user to change the frequency
in 25kHz steps.
•
(User-Programmable Groups Only) Use the [UP]/[DOWN]
arrow buttons to change the frequency.
•
(User-Programmable Groups Only) Press [SET] to place
the beltpack on the frequency selected. If set is held
down, during that time the group is displayed so the user
is aware of what group the unit has been placed. Once set
is released, the unit returns to the receive 2 frequency
screen with nothing flashing.
•
(User-Programmable Groups Only) Pressing [SET] once
more will start the editing sequence over again. Pressing
[MENU] during receive 2 frequency edit will end editing
and send the user back to the receive 2 screen without any
changes.
[UP] / [DOWN]
[SET] IS HELD DOWN
[SET] IS RELEASED
6-17
Receive 2 Screen
R2
565.350
[SET]
R2
565.350
R2
567.850
27u
GP
R2
567.850
END