Solid Wall Installation - Mira Coda Installation & User Manual

solid Wall Installation

For solid wall installations the thermostatic bar valve can be supported by the
pipework provided that it is securely fixed to the wall. Alternatively for unfixed rear
entry pipework the wall mounting bracket can be used.
For installation onto a stud partition, laminated panel, or onto unfixed rear-entry
pipework (using the wall mounting bracket) refer to section: 'stud Partition,
Laminated Panel, or Unfixed Rear-entry Pipework Installation'.
1. Install the pipework, making sure that it is set at the correct distance apart
(150 ± 24 mm) and solidly fixed.
2. Apply suitable thread sealant (not supplied) and attach the offset connectors
to the pipework in the wall. The offset connectors must protrude between 35
and 40 mm from the finished wall.
note! Connections are: Hot-Left, Cold-right. This is very important as this
product does not allow for reversed inlets.
½" BSP Female
Connection
Pipework
Support
Bracket
3. Tighten the offset connectors using a
spanner on the spanner flats. Make
sure that the connectors are level
and set at the correct distance apart,
using the bar valve as a guide to
spacing.
4. Screw the concealing plates onto the
offset connectors until they come into
contact with the wall.
35 - 40 mm
Offset
Connector
Tile
apply Silicone
Sealant to seal
hole in wall
Wall
Spirit Level
150 ± 24 mm
Spanner Flats
Hot
10
150 mm
Cold
Concealing Plates