Gas Connection - CDA PZ 10/2 User Operating Instructions Manual

Gas connection

The installation of the cooker to Natural Gas or LP Gas must be carried out by a qualified gas
engineer. Installer shall take due account of the provisions of the relevant British Standards
Code of Practice, the Gas Safety Regulations and the Building Standards (Scotland)
(Consolidation) Regulations issued by the Scottish Development Department.
Installation to Natural Gas
Installation to Natural Gas must conform to the Code of Practice, etc. The supply pressure
for Natural Gas is 20 mbar.
Installation to LP Gas
This appliance must only be connected to LPG after an LPG conversion kit has been fitted,
(see pages from 40 to 42).
When operating on Butane gas a supply pressure of 28-30 mbar is required.
When using Propane gas a supply pressure of 37 mbar is required.
The installation must conform to the relevant British Standards.
Warning: Only a qualified gas engineer, also with technical knowledge of electricity should
install the cooker. He should observe the Regulations and Codes of Practice governing such
installation of gas cookers.
Note: It is recommended that the gas connection to the cooker is installed with a
flexible connecting tube made to BS 5386.
38