TurboChef i3 Service Manual page 43

CAUTION: This procedure should be
performed while oven is hot. To avoid burns,
be careful when adjusting the oven door.
1. Turn the oven on and warm it to its operating
temperature. If two temperatures are present,
warm the oven to the higher of the two
temperatures.
2. Remove the oven side panels.
3. Remove the switch assemblies from each side.
4. Loosen the four screws that hold the hinge
assembly to the gusset plates (Figure 31A).
5. Slide the door in and out of the cavity, making
sure the gaps between the door and cavity face
are the same distance on each side. Figures 31B
and 31C show misaligned doors.
6. Tighten the four screws and open/close the
door multiple times to confirm adjustment.
Tap this
corner
Figure 31B: Door Misaligned 1 - Side Views
Oven
Frame
Loosen
Screws
Oven
SM Switches
Door
Hinge
Figure 31A: Properly Adjusted Door - Side Views
7. Reinstall the door switches.
8. With the door closed, set the left side switch
(primary) so the paddle is closed but not
pushing or binding on itself.
9. Set the right side switches (secondary and
monitor) so they are completely closed but not
pushing or binding on themselves.
10. Turn the oven on and enter
16 for more details).
11. Observe the status indicators when opening
and closing the door and confirm the sequence
(PSM open, MSP closed). If necessary, adjust the
switches (page 24) and reconfirm the sequence.
12. Reinstall the side panels.
13. Perform a MW Leak Test (pages 25-26).
Oven
Frame
Loosen
Screws
P Switch
Hinge
Tap this
corner
Figure 31C: Door Misaligned 2 - Side Views
(page
TEST MODE
Oven
Door
Remove
switches
and tap here
23