Yamaha Apex RX10RZ Owner's Manual page 76

Periodic maintenance and adjustment
1. Left adjusting nut
2. Right adjusting nut
Shifted to right
1. Forward
2. Gap
3. Slide runner
4. Drive track
5. Slide metal
Shifted to left
1. Forward
2. Gap
3. Slide runner
4. Drive track
5. Slide metal
70
5. Adjust the drive track deflection to speci-
fication. NOTICE: The right and left ad-
justing nuts should be turned an equal
amount.
[ECS00592]
Drive track More than
deflection specified
Left adjusting
nut
Right adjust-
ing nut
6. Recheck alignment and deflection. If nec-
essary, repeat steps 3 to 5 until the prop-
er adjustment is achieved.
7. Lower the snowmobile to the ground.
8. Tighten the rear axle nut.
Rear axle nut tightening torque:
75 Nm (7.5 m·kgf, 54 ft·lbf)
Slide runners
Check the slide runners for wear and dam-
age.
If the slide runners reach the wear limit, they
should be replaced.
1. Slide runner
2. Wear limit height
Slide runner wear limit height:
10.5 mm (0.41 in)
Less than
specified
Turn in Turn out
Turn in Turn out