Tool Kit; Removing And Installing The Shroud And Covers - Yamaha Apex RX10RZ Owner's Manual

Periodic maintenance and adjustment
ESU11741

Tool kit

The service information included in this man-
ual and the tools provided in the owner's tool
kit are intended to assist you in the perfor-
mance of preventive maintenance and minor
repairs. However, additional tools such as a
torque wrench may be necessary to perform
certain maintenance work correctly.
1. Tool kit
ECS00360
NOTICE
Before starting the engine, make sure that
the tool kit is properly seated in its holder
and is securely fastened.
TIP
If you do not have a torque wrench available
during a service operation requiring one, take
your snowmobile to a Yamaha dealer to
check the torque settings and adjust them if
necessary.
ESU12894
Removing and installing the
shroud and covers
EWS00091
WARNING
Be sure shroud and covers are secured
before operation. A loose shroud or cover
could move and cause loss of control.
46
Shroud
To remove the shroud
Loosen the fasteners, slowly raise the shroud,
and then unhook the shroud from the shroud
stay.
1. Fastener
2. Shroud
3. Shroud stay
To install the shroud
Hook the end of the shroud onto the shroud
stay, slowly lower it to the original position,
and then tighten the fasteners.
1. Shroud stay
Left and right side covers
To remove a side cover
1. Remove the shroud. (See the above pro-
cedure.)
2. Loosen the fasteners, and then remove
the side cover.
1
2
3