Yamaha Apex RX10RZ Owner's Manual page 34

Control functions
Rebound damping setting:
Minimum (soft):
22 click(s) in direction (b)*
Standard:
With the adjusting dial fully turned
in direction (a)
Maximum (hard):
With the adjusting dial fully turned
in direction (a)
* With the adjusting dial in the standard
position
ESU11046
Adjusting the control rods
The weight transfer can be adjusted by turn-
ing the adjuster on the control rod (RX10R /
RX10LT) or the adjusting nuts on the control
rods (RX10MT).
RX10R / RX10LT
1. Check the control rod length using the
scale on the special wrench as shown.
TIP
In order to obtain a precise measurement, the
special wrench corner should touch the con-
trol rod adjuster, and the locknut must be
turned so that one of its notches aligns with
the wrench allowing the wrench to fit horizon-
tally on the control rod.
1
2 5
1. Special wrench corner
2. Control rod adjuster
3. Scale range
4. Special wrench
5. Control rod length
28
3 4
Min Max
TIP
Use the special wrench in the owner's tool kit
to make this adjustment.
2. Loosen the locknut.
3. To increase weight transfer, turn the ad-
juster in direction (a), and to decrease
weight transfer, turn it in direction (b).
WARNING! Never adjust the control
rod beyond the range of the scale on
the special wrench, otherwise the con-
trol rod could be damaged, which
could lead to an accident or injury.
[EWS00181]
1. Locknut
2. Control rod adjuster
4. Tighten the locknut while holding the ad-
juster in place.
TIP
Make sure that the special wrench is securely
fitted on the locknut.