Lorex LH330 Edge2 Series Instruction Manual page 122

Appendix E: Internet Setup Wizard (PC only)
A proper DMZ configuration in Router 2 allows all incoming traffic going through Router 2
to automatically pass to Router 1. Router 2 acts as a "dummy" router and passes all the
incoming data onto Router 1. Router 1 is the router that needs the port forwarding
information.
Configuring a DMZ host connection:
1 Connect to "Router 1" on your network
(referred to as "Possible 1st Router" in the
Auto Port Forwarding Wizard). Obtain the IP
address of Router 1. Usually this can be
found in the "Status" section of your router
menu. The IP should begin with
"192.168...."This IP address is your DMZ IP.
2 Enter the IP address obtained from Router 1
into the DMZ section of Router 2.
3 Once you have configured Router 2 with a
DMZ connection, run the Auto Port
Forwarding Wizard to begin auto port
forwarding to Router 1.
NOTE: Consult your router's owner's manual for details on configuring DMZ settings.
Locating your Router IP - The Status Page
The "Status Page" of a router normally includes the
router's vital information such as the IP address.
EXAMPLE
106
Example
DMZ stands for Demilitarized Zone. Enabling a
DMZ IP on your router enables one of the routers
to pass information onto the second router.
DMZ IP address
assigned by a
secondary router
The IP information is
normally under a
header called "WAN"
or "Internet Port".
Each router has
different terminology.
Router IP assigned by
the main router.
Enter this IP into the
DMZ section of the
primary router.