Removal Of The Transformer; Removal Of The Dust Sensor - Rinnai RCE-460PTR Service Manual

d. Remove the eight (8) screws securing the fan
housing to the back panel.
e. Remove the capacitor to the right of the fan
housing (1 screw) and wiring loom from the
main PCB.
f. Further disassembly would be required to
replace motor as shown below.

5. Removal of the Transformer

CAUTION
240 Volt exposure. Isolate the electrical supply to
the appliance and reconfirm with the neon
screwdriver or multimeter.
a. Follow section 3 (Removal of the Front
Panel).
b. Remove one (1) screw from the right hand
bracket.
Convector 460/560PTR
c. Disconnect 3 connectors (main PCB, surge
protector and dust sensor. Follow section 6 to
remove dust sensor.)
d. Disengage transformer.

6. Removal of the Dust Sensor

240 Volt exposure. Isolate the electrical supply to
the appliance and reconfirm with the neon
screwdriver or multimeter.
a. Follow section 3 (Removal of the Front
Panel).
b. Remove two (2) screws.
c. Remove protective plastic cover. (2 screws)
d. Remove two (2) connectors.
e. Further disassembly would be required to
replace the dust sensor as shown below
- 49 -
CAUTION
©Rinnai