Removal Of The Purifier Filter; Removal Of The Control Panel Assy; Removal Of The Front Panel; Removal Of The Purifier Fan Assembly - Rinnai RCE-460PTR Service Manual

1. Removal of the Purifier Filter

CAUTION
240 Volt exposure. Isolate the electrical supply to
the appliance and reconfirm with the neon
screwdriver or multimeter.
a. Remove the thumb screw (1 screw).
b. Remove the Primary Filter, then the Purifier
Filter.

2. Removal of the Control Panel Assy

CAUTION
240 Volt exposure. Isolate the electrical supply to
the appliance and reconfirm with the neon
screwdriver or multimeter.
a. Remove 5 screws (1 on each side, 3 at the
back.).
b. Lift from the back first, then disengage from
the catches on the front panel.
c. Remove the Front Panel (refer to section 3 -
Removal of Front Panel).
d. Remove the screw from the indicator and dis-
engage the two (2) clips from the securing
bracket.
e. Disconnect 3 (three) wiring loom connectors
from PCB.
Convector 460/560PTR

3. Removal of the Front Panel

240 Volt exposure. Isolate the electrical supply to
the appliance and reconfirm with the neon
screwdriver or multimeter.
a. Remove three (3) bottom screws (1 on each
side, 1 at front).
b. Follow sections 2. a. and b.
c. Lift the front panel slightly, and pull towards
you.

4. Removal of the Purifier Fan Assembly

240 Volt exposure. Isolate the electrical supply to
the appliance and reconfirm with the neon
screwdriver or multimeter.
a. Follow section 3 (Removal of the Front
Panel).
b. Remove the top securing bracket (3 screws).
c. Remove one (1) screw from the bottom secur-
ing bracket.
- 48 -
CAUTION
CAUTION
©Rinnai