Network Connection; Important Information Regarding The Hdmi Connection - Sherwood R-807 Operating Instructions Manual

R-807 NETWORk AV RECEIVER

NETWORk CONNECTION

Symptom
The main unit cannot
connect to the WPS via a
wireless LAN connection.
The receiver cannot connect
to the network.
Cannot select the Network
Settings menu.

Important Information Regarding the HDmI Connection

Some HDMI signals cannot be routed through this system. (This depends on the HDMI-equipped component you are
connecting. Check with the manufacturer for HDMI compatibility information.)
If you cannot receive HDMI signals properly through the main unit (from your component), please try the following
configuration when connecting.
54
• You cannot connect to a network using WPS when your access point is set to
WEP. Set up your network after searching the access point using the access
point scan.
• Check the network status.
When the system is connected through a wireless network, move the main unit
•
and the wireless LAN router/access point closer to each other and do the setup
again.
• Check the settings of the wireless LAN router/access point and do the
setup again. For details on the settings of the devices, refer to the operating
instructions of the devices.
• Make sure that you use a wireless LAN router/access point.
• Wireless networks are influenced by electromagnetic radiation emitted by
microwave ovens and other devices. Move the main unit away from these
devices
•
Wait for a few moments after you have turned on the main unit, and then select
the Network Settings menu again.
Remedy