Sherwood R-807 Operating Instructions Manual page 45

Caution
• Since the microphone for Auto Setup is designed
exclusively for this receiver, do not use a
microphone other than the one supplied with this
receiver.
3
Place the microphone on a flat level surface at
the listening position.
• If possible, use a tripod or to fix the
microphone at the same height as your
ears would be when you are seated in your
listening position.
• Ensure there are no obstacles between the
speakers and the microphone.
4
Press  or  to select the Auto Setup, and then
press  button.
5
Press  to start the auto setup procedure.
• Loud test tones are output played
successively and when the auto
setup procedure has been completed,
"COMPLETED" will be displayed.
• To stop the auto setup procedure while
performing it, press .
• If there is a problem with speaker or
microphone connection, an error message will
be displayed. In this case, turn off the power,
check the connection and then retry the auto
setup procedure.
6
Press  to memorize the results.
• The results are memorized and the Speaker
Setup menu is displayed.
• When  is pressed to select "CANCEL", the
results are not memorized.
• Check the results on each setup menu
("Speaker Config", "Speaker Crossover",
"Speaker Distance" and "Channel Level"
menu on page 46).
7
Disconnect the microphone after you have
completed the auto setup procedure.
Caution
• Because the test tones are loud, ensure there are
no infants or young children in the room.
Note
• For best results, ensure the room is as quiet as
possible during the auto setup procedure. If there
is too much ambient noise, the results may not
be satisfactory.
• If the results are not satisfactory, you can retry
the auto setup procedure or personalize your
speaker setup and channel level setup by
choosing the settings manually. For details, see
"Speaker Config", "Speaker Crossover", "Speaker
Distance" and "Channel Level" procedure on
page 46.
Customizing Settings
45