VarTech Systems VTPC190P User Manual page 8

AC Models: The Panel Mount PC includes an AC line cord which is 6ft long. The power input
receptacle is located on the bottom rear panel of the system.
DC Models: The Panel Mount PC with two binding posts, one red and one black. Red is for
connecting +9-32VDC and black is for power ground. Connect to any DC power source that
does not exceed 15A of current. (15A mini-blade fuse protected)
Serial Connections (COM 1-3)
The Panel Mount PC is supplied with three serial connectors configured for RS-232. The
connector is a 9 pin female connectors and can be set up for any baud rate from 300 to 19.2
baud. The connector is located on the bottom panel of the system.
Ethernet Connections (LAN 1-2)
The Panel Mount PC is supplied with two integrated Ethernet connectors. The interface will
support 10/100/1000 BaseT connection to a local area network (LAN). The Panel Mount PC is
supplied with two RJ-45 female connectors located on the bottom panel of the system.
USB Connections (USB 1-4)
The Panel Mount PC is supplied with four USB 2.0 connectors located on the bottom front panel
of the system.
VGA Port
The 15-pin female VGA connector can be used to connect to any analog VGA monitor.
IEEE1394a (Firewire)
The Panel PC is supplied with two IEEE1394a ports which feature high speed, high bandwidth
which are hot pluggable to connect with IEEE1394 devices and peripherals.
Turning the system On and Off
Before connecting the Panel Mount PC to power, connect any peripheral devices. As a general
rule, any peripheral device should only be connected or disconnected when the Panel Mount PC
is off with the exception of any USB or 1394 peripheral.
The Panel Mount PC is turned on using the main On-Off rocker switch located on the bottom
rear panel. Once the Panel Mount PC main switch is turned on the computer power pushbutton
switch must be depressed for Windows to start. Windows must be properly shut down before
the main power switch is turned off to prevent the chance of corrupting files in the operating
system.
The Panel Mount PC is rated for continuous duty. However, to extend the life of the various
components and conserve power, it is highly recommended that the system be properly shut
down and power turned off when the Panel Mount PC is not in use.
LCD Monitor Warm-up Time
19.0 Panel Mount PC 8 486-0010-01-02